Type “netsh interface ipv4 add address name= store=persistent” to set a static IP address for your network interface.Open the Windows Command Prompt, and type “netsh interface ipv4 show config” to verify that NAT is enabled.Check the “ Enable IPV4 NAT” box, and then click the “OK” button.Select the “Advanced” option, and click the “IP Settings” tab.Select the “Internet Protocol Version 4 (TCP/IPv4)” and click Properties.Right click on the network interface that you want to enable NAT, and then click Properties.Click on “Change Adapter Settings” in the left column.You should now test your port forwarding to ensure everything is configured correctly. Your new port forwarding rule will be enabled and active in the Windows Firewall with Advanced Security console. On the Name window, enter a name for your port forwarding rule and click Finish.In most cases, the default selections are fine, but you can choose to only enable the rule for a specific profile if required. On the Profile window, you can choose to which profiles the rule should apply.On the Action window, choose Allow the connection and then click Next.On the Protocols and Ports window, select TCP and enter the specific port or range of ports that you would like to forward.On the New Inbound Rule Wizard window, select the Port radio button and then click Next. ![]() In the left-hand navigation of the console, select Inbound Rules and then select the New Rule link in the right-hand menu.Launch the Windows Firewall with Advanced Security console by opening the Start menu, navigating to Administrative Tools, and selecting Windows Firewall with Advanced Security.Netsh routing IP NAT add portmapping name="Public" tcp 0.0.0.0 80 192.168.15.151 80Ĭontinue reading here: More Info Configuring Nat Using Netsh 168.15.151 on the internal network, issue this command: For example, to map port 80 on the NAT server's public interface to port 80 on host 192. If there are multiple public IP addresses, you can specify them individually. 0 if the NAT server has a single public IP address. Where "Public" is the interface name, X is the external port, Y is the IP address of the internal host, and Z is the port on the internal host. Netsh routing IP NAT add portmapping name="Public" tcp 0.0.0.0 X Y.Y.Y.Y Z To configure port forwarding from netsh for Routing and Remote Access-enabled NAT, use the following command: ![]() You can also configure port forwarding from the netsh command-line tool. In the Edit Service dialog box, shown in Figure 3-10, specify the IP address of the internal network host to which NAT will forward traffic on this port. This displays the Edit Service dialog box.Ĥ. On the Services And Ports tab, select the check box for the service you want forwarded from the network interface connected to the Internet to a host on the internal network and click Edit. This opens the Network Interface Connection Properties dialog box.ģ. Right-click the network interface connected to the Internet, and then select Properties. ![]() Open the Routing And Remote Access console and navigate to the Server\IPv4\NAT nodeĢ. To configure port forwarding from the Routing and Remote Access console, perform the following steps:ġ. This means that you cannot forward requests to different hosts on the internal network that arrive on the same interface based on the hostname used with the request. Port forwarding works based on interface address rather than on hostname. For example, you could map port 80 on the NAT server's public interface so that it redirects to a Web server located on your internal network. Port forwarding enables you to redirect traffic targeted at a port on the NAT server's public interface to a host on the internal network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |